Galil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 Amplifiers
Galil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 AmplifiersGalil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 AmplifiersGalil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 AmplifiersGalil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 AmplifiersGalil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 AmplifiersGalil Motion Control ICM-1100/ AMP-1140 Interconnect Module w/ 3 10A8 Amplifiers
$250.00
Used. This board was pulled from a decommissioned piece of equipment after an upgrade. It is a little dusty but it is guaranteed working.

The ICM-1100 Interconnect Module breaks-out the 60- pin, 26-pin and (2) 20-pin ribbon cables into screw-type terminals for quick connection of system hardware. An ICM-1100 is required for each set of four axes. The ICM-1100 is mounted on a metal plate with dimensions of 5.7" x 13.4" x 2.5" and 1/4" diameter keyholes for mounting.

The AMP-1100 series is an ICM module above with up to 4 PWM amplifiers for brush-type servo motors. Each amplifier provides 7 amps continuous, 10 amps peak at up to 80 Volts. The gain of the amplifier is 1 A/V and requires an external DC supply from 20 to 80 Volts. The minimum motor inductance is 1 mH and the PWM frequency is 30Khz

The 10A8 PWM servo amplifiers are designed to drive brush type DC motors. The 10A8 is fully protected against over-voltage, over-current, over-heating and short-circuits across motor, ground and power leads. This amplifier interfaces with digital controllers or can be used as a stand-alone drive. The 10A8 requires only a single unregulated power supply. A potentiometer is located on the side for loop gain adjustment.